## Overview Allow "「Reference Copy」" of records. Set this to on if you want to allow "「Reference Copy」". If "「Reference Copy」" is not allowed, the reference copy button in the "[Editor](/en/manual/table-management-editor)" will be hidden. When you perform a reference copy, the data is copied in the state before it was created, and you can create a record after changing the necessary information. ## Prerequisites 1. "Site Administration Permission" is required to configure settings. ## Default Value The default value is off. It can be changed by "AllowReferenceCopy" in "[General.json](/ja/manual/general.json)". ## Operation Procedure 1. Open the target "[Table](/en/manual/table)". 1. Click "「Table Management」" from the "Manage" menu. 1. Open the "[Editor](/en/manual/table-management-editor)" tab. 1. Check or uncheck the "Allow Reference Copy" checkbox at the bottom of the screen. 1. Click the "Update" button at the bottom of the screen. ## Operation Image When a reference copy is allowed, the reference copy button will be displayed.  When you perform a reference copy, you will be taken to the new creation screen. At this point, no record is created.  Enter the required information and create a record. ## Related Information <div id="ManualList"><ul><li><a href="/en/manual/general.json">パラメータ設定：General.json</a><span>06.12.2024 up</span></li></ul></article> <ul><li><a href="/en/manual/table">Table Function</a><span>08.13.2024 up</span></li></ul></article> <ul><li><a href="/en/manual/table-management-editor">Table Management: Editor</a><span>08.13.2024 up</span></li></ul></article></div><input id="SearchTextHidden" type="hidden" value="" />